BS ISO 10145-1:2016 pdf download.End mills with brazed helical hardmetal tips — Part 1: Dimensions of end mills with parallel shank
1 Scope
This part of ISO 10145 specifies the general dimensions of end mills with brazed helical hardmetal tips,with parallel shank.
The following two types of end mills with parallel shank are specified:
— end mills with plain parallel shank;
— end mills with flatted parallel shank.
This part of ISO 10145 applies to right-hand and left-hand end mills, irrespective of the helix angle and number of flutes.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3338–1, Parallel shanks for milling cutters — Part 1: Dimensions of plain parallel shanks
ISO 3338–2, Cylindrical shanks for milling cutters — Part 2: Dimensional characteristics of flatted cylindrical shanks
3 Dimensions
The dimensions for end mills as shown in Figure 1 are specified in Table 1.
BS ISO 10145-1:2016 pdf download
