BS EN 6126:2018 pdf download.Aerospace series – Fitting end, 24° internal cone
1 Scope
This standard specifies the dimensions, tolerances and the required characteristics of a fitting end, 24° cone, external thread, flareless type, size -32 for use in hydraulic and fluid systems at 220 psi, diameter D = 2 inches (D = 50,8 mm) for aerospace applications.
This is a design standard, not valid for order.
This fitting can not be used for plug in union.
2.Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3161, Aerospace – UN] threads – General requirements and limit dimensions
3 Requirements
3.1 Configuration, dimensions and tolerances
The configuration, dimensions and tolerances shall conform with Figure 1 to Figure 5, Table 1 and Table 2.
Dimensions and tolerances are expressed in inch (millimetres).
BS EN 6126:2018 pdf download
![BS EN 6126:2018 pdf download](https://www.onlinestandardssearch.com/wp-content/uploads/2022/10/8-101.png)