BS EN 4710-03:2018 pdf download

BS EN 4710-03:2018 pdf download.Aerospace series – Quick release fastening systems for non-structural applications
1 Scope
This European standard specifies the dimensions, mass, tolerances and static values of spring clamps for use in fuselage interior equipment and non-structural or secondary structural area. This standard part shall be used in conjunction with EN 4710-06 and EN 47 10-07 as described in EN 4710-02.The applicable temperature range is -55。C to 85 °C.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
DIN EN ISo 19598, Metallic coatings一Electroplated coatings of zinc and zinc alloys on iron or steel with supplementary CR(Vl)-free treatment (ISO 19598:2016)
EN 2424, Aerospace series一Marking of aerospace products
EN 2516， Aerospace series 一Passivation of corrosion resisting steels and decontamination of nickel base alloys
EN 4710-01, Aerospace series一Quick release fastening systems for non-structural applications – Part 01: Technical specification
EN 47 10-02，Aerospace series 一Quick release fastening systems for non-structural applications 一Part 02: Spring clamp stud combination
EN 4710-06, Aerospace series一Quick release fastening systems for non-structural applications – Part 06: Stud – quick-release and locking
EN 4710-07, Aerospace series一- Quick release fastening systems for non-structural applications一 Part 07: Retaining grommet
EN 10132-4, Cold rolled narrow steel strip for heat treatment一Technical delivery conditions一Part 4: Spring steels and other applications
EN 10151, Stainless steel strip for springs一Technical delivery conditions
EN 22768-1:1993, General tolerances – Part 1: Tolerances for linear and angular dimensions without individual tolerance indications (ISO 2768-1:1989)
EN 22768-2:1993, General tolerances – Part 2: Geometrical tolerances for features without individual tolerance indications (ISO 2768-2:1989)
3 Requirements
3.1 Configuration, dimensions, tolerances and mass
The configuration, dimensions, tolerances and mass shall conform with Figure 1 and Table 1. Tolerances not specified, shall be in accordance with ISO 2768-mK (EN 22768-1:1993 and EN 22768-2:1993].Dimensions are unless otherwise specified per manufacturer s option.