ASME A112.19.3:2017 pdf free download

ASME A112.19.3:2017 pdf free download.Stainless steel plumbing fixtures.
Bidet — a fixture with a hot and cold water supply intended for genital and perineal hygiene. Defect –
Blemish — a dent, depression, or raised portion on the visible stainless steel surface of a fixture, Crack — a fracture in the surface or substrate material of a fixture.
Die mark — a visible scoring of the stainless steel surface of a fixture.
Pinhole — a hole in the stainless steel surface of a fixture whose largest dimension Is 1.5 mm (0.06 in) or less.
Wrinkle — a corrugation in the stainless steel surface of a fixture that is visible or can be felt.
Fitting — a device that controls and guides the flow of water.
Note: See ASME 4112. 18.1/CSA 81251 and CSA 8125.3 for definitions of specific types of fittings.
Fixture — a device that receives water, waste matter, or both and directs these substances into a drainage system.
Note: See ASME A112.19.2/CSA 845.1 for definitions of specific types of fixtures.
Flange —
a) the flat area on the front or sides of a compartment in a sink or lavatory; or
b) the raised vertical section for retaining water In a tub or shower base.
Flat-rim sink (rim-back sink) — a single. or double-compartment sink with flanges on all sides but no back ledge (ledge-back).
Flood level — the level at which water will overflow a fixture.
Flushometer valve — a flushing device attached to a pressurized water supply pipe that, when actuated, opens the pipe for direct flow Into the fixture at a rate and in a quantity that enables proper operation of the fixture. The valve then gradually closes to provide trap reseal in the fixture and avoid water hammer.
Note: rhe pipe to which the flushorneter valve is connected should be large enough to enable it to deliver water at a sufficient rare of flow for flushing.
Horizontal surface — a surface forming an angle with the horizontal of less than 45.
Integral rim — a mounting rim that is an integrally formed part of a sink flange and has clamp-down devices for attaching the sink to the countertop.
Lavatory — a washbowl or basin.
Ledge — the flat area of a sink or lavatory on which supply fittings are normally mounted.
Ledge-back sink — a single- or double-compartment sink with a ledge along the back that has openings for mounting supply fittings.
Mirror finish — a highly reflective finish with no visible polishing lines. Rim — the unobstructed open edge of a fixture, Satin finish — a surface with a soft sheen consisting of fine, regular polish lines in a uniform pattern.