BS EN ISO 08936:2017 pdf download

BS EN ISO 08936:2017 pdf download.Awnings for leisure accommodation vehicles — Requirements and test methods
1 Scope
This document specifies requirements, test methods and material performance characteristics for vehicle awnings. It applies to awnings intended to be pitched and struck.
This document is not applicable to:
a) sun awnings: structure detachable from the vehicle which is used to provide shelter from the sun, but is not designed or constructed to provide shelter from wind, rain or snow; NOTE 1 A sun awning can be used with additional front and side panels to form an enclosure, but this enclosure would not meet the requirements of an awning as defined in this document.
b) external blinds: structure permanently fixed to a vehicle which is used to provide shelter from the sun, but is not designed or constructed to provide shelter from wind, rain or snow; NOTE 2 An external blind can be used with additional front and side panels to form an enclosure, but this enclosure would not meet the requirements of an awning as defined in this document.
c) fixed awnings: permanent awning which is not designed for mobile use.
EXAMPLE Awnings equipped with square aluminium frames or timber supporting structures and the possibility to install living compartment windows and doors.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 105-B02, Textiles — Tests for colour fastness — Part B02: Colour fastness to artificial light: Xenon arc fading lamp test
ISO 105-B04, Textiles — Tests for colour fastness — Part B04: Colour fastness to artificial weathering:Xenon arc fading lamp test
ISO 105-E01, Textiles — Tests for colour fastness — Part E01: Colour fastness to water
ISO 105-X12, Textiles — Tests for colour fastness — Part X12: Colour fastness to rubbing
ISO 811, Textile fabrics — Determination of resistance to water penetration — Hydrostatic pressure test
ISO 1421, Rubber- or plastics-coated fabrics — Determination of tensile strength and elongation at break
ISO 2081, Metallic and other inorganic coatings — Electroplated coatings of zinc with supplementary treatments on iron or steel
ISO 4675:1990, Rubber- or plastics-coated fabrics — Low-temperature bend test
ISO 4892-2:2013, Plastics — Methods of exposure to laboratory light sources — Part 2: Xenon-arc lamps
ISO 5912:2011, Camping tents
ISO 6925, Textile floor coverings — Burning behaviour — Tablet test at ambient temperature
ISO 6941:2003, Textile fabrics — Burning behaviour — Measurement of flame spread properties of vertically oriented specimens
ISO 7152, Camping tents and caravan awnings — Vocabulary and list of equivalent terms
ISO 7771, Textiles — Determination of dimensional changes of fabrics induced by cold-water immersion
ISO 9227, Corrosion tests in artificial atmospheres — Salt spray tests
ISO 13934-1, Textiles — Tensile properties of fabrics — Part 1: Determination of maximum force and elongation at maximum force using the strip method
ISO 13937-2, Textiles — Tear properties of fabrics — Part 2: Determination of tear force of trouser-shaped test specimens (Single tear method)
EN 15977:2011, Rubber or plastic coated fabrics — Mechanical properties — Determination of the
elongation under load and the residual deformation