BS ISO 17987-6:2016 pdf download

BS ISO 17987-6:2016 pdf download.Road vehicles — Local Interconnect Network (LIN) — Part 6: Protocol conformance test specification
1 Scope
This document specifies the LIN protocol conformance test. This test verifies the conformance of LIN communication controllers with respect to ISO 17987-2 and ISO 17987-3.
This document provides all necessary technical information to ensure that test results are identical even on different test systems, provided that the particular test suite and the test system are compliant to the content of this document.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 17987-2:2016, Road vehicles — Local Interconnect Network (LIN) — Part 2: Transport protocol and network layer services
ISO 17987-3:2016, Road vehicles — Local Interconnect Network (LIN) — Part 3: Protocol specification
ISO 17987-4:2016, Road vehicles — Local Interconnect Network (LIN) — Part 4: Electrical Physical Layer (EPL) specification 12V/24V
3 Terms, definitions, symbols and abbreviated terms
3.1 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— IEC Electropedia: available at http://www.electropedia.org/
— ISO Online browsing platform: available at http://www.iso.org/obp
3.1.1 class B device
μC-based LIN device
Note 1 to entry: These are devices where it is possible to take measurements on the Rx and Tx interface circuits between the μC and the transceiver.
3.1.2 class C device
integrated LIN devices (ECU) with μC and transceiver
Note 1 to entry: These are devices where it is not possible to take measurements on the Rx and Tx interface circuits between the μC and the transceiver.
5.4 Mandatory requirements for IUT as slave
The NCF or alternatively the LDF is mandatory to perform the LIN conformance tests for IUT as slave. The used test tool shall verify the syntax of the NCF/LDF for plausibility (not for the content). The NCF/LDF shall match with the implementation of the device. If the NCF/LDF is not able to describe all features of the IUT, an additional device specific datasheet is necessary (for example, used diagnostic services). If an IUT is not fully configured after reset, an IUT initialization is required before each test case, except if the AssignFrameIdentifierRange command is part of the test. Preconfigured slaves are fully configured after reset. Deviations are marked in the test case respectively.