BS ISO 19356:2016 pdf download

BS ISO 19356:2016 pdf download.Ships and marine technology — Marine cranes — Test specifications and procedures
1 Scope
This document describes the required tests and the testing procedures for marine cranes of metal construction.
This document is applicable to the following types of marine cranes:
— deck cranes mounted on ships for handling cargo or containers in harbour or sheltered water conditions;
— floating cranes or grab cranes mounted on barges or pontoons for operating in harbour conditions;
— engine room cranes, provision cranes, etc. mounted on ships (including floating docks) for handling equipment and stores in harbour conditions.
NOTE Marine cranes in other types can refer to this document.
This document does not apply to the following:
— minimum ambient operating temperatures below −20 °C;
— maximum ambient operating temperatures above +45 °C;
— loads from accidents or collisions;
— lifting operations below sea level;
— transport, assembly, dismantling and decommissioning of cranes;
— lifting accessories, i.e. any item between the crane and the load;
— lifting operations involving more than one crane;
— hand-powered cranes;
— emergency rescue operations;
— shore-side cargo handling cranes;
— portable cranes on board;
— lifting appliances for lifeboats, liferafts accommodation ladders, and pilot ladders;
— launching appliances for survival craft and rescue boats;
— gangways, accommodation and pilot ladders and their handling appliances.
Cranes defined in this document are intended to comply with the requirements of class societies and flag states. It is also intended that reference be made to ILO and particularly the convention No. 152.Applicable regulations are those issued by the responsible classification societies and it is intended that
national authorities be complied with.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 13202, Cranes — Measurement of velocity and time parameters
ISO 14518, Cranes — Requirements for test loads
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 3828, ISO 4306-1, ISO 8431 and ISO 19354 and the following apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— IEC Electropedia: available at http://www.electropedia.org/
— ISO Online browsing platform: available at http://www.iso.org/obp
3.1 bench test
test made on the test bench of the manufacturer
4 Test specification and procedure requirements
4.1 General requirements
4.1.1 The test shall be carried out for the marine crane according to specified technical performances and main parameters shall be verified.
4.1.2 The test load of the marine crane shall comply with ISO 14518.
4.1.3 The measurement of the test speed and time parameters of the marine crane shall comply with ISO 13202.
4.1.4 The marine crane components shall be tested according to applicable regulations.
4.1.5 The marine crane shall be tested according to the test program made by the designer.