IEC 60705:2010 pdf free download

IEC 60705:2010 pdf free download Household microwave ovens – Methods for measuring performance
1 Scope
This International Standard applies to microwave ovens for household use. It also applies tocombination microwave ovens.
This standard defines the main performance characteristics of household microwave ovenswhich are of interest to the user, and it specifies methods for measuring these characteristics.
NOTE 1 This standard does not deal with
– ovens which cannot accept a load having a diameter of z200 mm;- safety requirements (see lEC60335-2-25 [1]*and lEC 60335-2-90 [2]).
NOTE 2 This standard does not apply to ovens incorporating conventional heating means only (see IEC 60350)[3].
2Normative references
The following referenced documents are indispensable for the application of this document.Fordated references,only the edition cited applies.For undated references, the latest edition ofthe referenced document (including any amendments) applies.
ISo 80000-1:2009,Quantities and units – Part 1: General
3Terms and definitions
For the purpose of this document, the following terms and definitions apply.
3.1
microwave oven
appliance using electromagnetic energy in the lSM frequency band of 2 450 MHz, for heatingfood and beverages in the cavity
NOTE 1 The microwave oven may incorporate a browning element.
NOTE 2 ISM frequency bands are the electromagnetic frequencies established by the lTU and reproduced inCISPR 11[4].
3.2
combination microwave oven
microwave oven in which the microwave energy is combined with thermal energy
3.3
microwave transparent
property of a material having negligible absorption and reflection of microwaves
NOTEThe relative permittivity of a microwave transparent material is less than 7 and the relative loss factor is lessthan 0,015.
3.4
rated voltage
voltage assigned to the appliance by the manufacturer
4 Classification
Appliances are classified according to their type and characteristics.
4.1 According to type
– Microwave ovens
– Combination microwave ovens
The type of oven shall be stated in the report.
4.2 According to characteristics
– Usable cavity dimensions
– With or without a turntable
The characteristics of the oven shall be stated in the report.
5 List of measurements
Performance is measured by the tests listed in Table 1 .