IEC 62282-7-2:2021 pdf free download Fuel cell technologies – Part 7-2: Test methods – Single cell and stack performance tests for solid oxide fuel cells (SOFCs)
This part of IEC 62282 applies to soFC cell/stack assembly units，testing systems,instruments and measuring methods,and specifies test methods to test the performance ofsOFC cells and stacks.
This document is not applicable to small button cells that are designed for soFC materialtesting and provide no practical means of fuel utilization measurement.
This document is used based on the recommendation of the entity that provides the cellperformance specification or for acquiring data on a cell or stack in order to estimate theperformance of a system based on it. Users of this document can selectively execute testitems suitable for their purposes from those described in this document.
Users can substitute selected test methods of this document with equivalent test methods ofIEC 62282-8-101 for solid oxide cell (soC) operation for energy storage purposes,operatedin reverse or reversible mode.
2 Normative references
The following documents are referred to in the text in such a way that some or all of theircontent constitutes requirements of this document. For dated references,only the editioncited applies.For undated references, the latest edition of the referenced document (including
any amendments) applies.
IEC 60050-485,International Electrotechnical Vocabulary(IEV) – Part485: Fuel celltechnologies (available at http://www.electropedia.org)
IEC 60584-1，Thermocouples – Part 1:EMF specifications and tolerances
IEC 60584-3,Thermocouples – Part 3:Extension and compensating cables – Tolerances andidentification system
IEC 61515，Mineral insulated metal-sheathed thermocouple cables and thermocouples
ISO 5168，Measurement of fluid flow – Procedures for the evaluation of uncertainties
ISO 6141，Gas analysis – Contents of certificates for calibration gas mixtures
ISO 6142-1 , Gas analysis – Preparation of calibration gas mixtures – Gravimetric method forClass l mixtures
ISO 6143,Gas analysis – Comparison methods for determining and checking the compositionof calibration gas mixtures
ISO 6145-7,Gas analysis – Preparation of calibration gas mixtures using dynamic methods -Part 7: Thermal mass-flow controllers
ISO 8573-1, Compressed air – Part 1: Contaminants and purity classes
ISO 8756, Air quality – Handling of temperature, pressure and humidity data
ISO 12185, Crude petroleum and petroleum products – Determination of density – Oscillating
U-tube method
3 Terms, definitions and symbols
Terms and definitions
3.1
For the purposes of this document, the terms and definitions given in IEC 60050-485 and the following apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
IEC Electropedia: available at http://www.electropedia.org/
ISO Online browsing platform: available at http://www.iso.org/obp
3.1.1
cell/stack assembly unit
unit including a single cell or stack, as well as gas supply parts, current collector parts, and any other peripherals as required for power generation tests
3.1.2
active electrode area
geometric electrode area upon which an electrochemical reaction occurs
Note 1 to entry: Usually this is the smaller of the anode and cathode areas.
IEC 62282-7-2:2021 pdf free download
