ISO 10582:2017 pdf download

ISO 10582:2017 pdf download.Resilient floor coverings — Heterogeneous poly(vinyl chloride) floor covering — Specifications
1 Scope
This document specifies the characteristics of non-cushioned, heterogeneous floor coverings, consisting of poly(vinyl chloride) (PVC), supplied in either tile or plank or roll form. Products can contain a transparent, non-PVC factory finish. To encourage the consumer to make an informed choice, this document includes a classification system (see ISO 10874) based on the intensity of use, which shows where these floor coverings give satisfactory service. It also specifies requirements for marking.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 105-B02, Textiles — Tests for colour fastness — Part B02: Colour fastness to artificial light: Xenon arc fading lamp test
ISO 4918, Textile floor coverings — Determination of wear — Castor chair test
ISO 16906, Resilient floor coverings — Determination of seam strength
ISO 23997, Resilient floor coverings — Determination of mass per unit area
ISO 23999, Resilient floor coverings — Determination of dimensional stability and curling after exposure to heat
ISO 24340, Resilient floor coverings — Determination of thickness of layers
ISO 24341, Resilient and textile floor coverings — Determination of length, width and straightness of sheet
ISO 24342, Resilient and textile floor-coverings — Determination of side length, edge straightness and squareness of tiles
ISO 24343-1, Resilient and laminate floor coverings — Determination of indentation and residual indentation — Part 1: Residual indentation
ISO 24344,Resilient floor coverings — Determination of flexibility and deflection
ISO 24346, Resilient floor coverings — Determination of overall thickness
ASTM F1515, Standard test method for measuring light stability of resilient flooring by colour change
EN 1372, Adhesives — Test method for adhesives for floor and wall coverings — Peel test
3 Terms and definitions
For the purposes of this document the following terms and definitions apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— IEC Electropedia: available at http://www.electropedia.org/
— ISO Online browsing platform: available at http://www.iso.org/obp
3.1 heterogeneous floor covering
floor covering consisting of a wear layer and other layers which differ in composition and/or design and can contain a reinforcement
3.2 poly(vinyl chloride) floor coverings
floor covering with all layers produced using poly(vinyl chloride) as base resin
3.3 wear layer
portion of a resilient floor covering that contains or protects the pattern and design exclusive of factory finishes or maintenance coatings
3.4 factory finish
transparent coating applied during the manufacture, usually not thicker than 0,03 mm not using poly(vinyl chloride) as base resin
3.5 binder content
portion of the flooring composition, consisting of poly(vinyl chloride) (PVC), plasticizers and stabilizers
Note 1 to entry: Binder content can be expressed as a percentage mass fraction of the considered layer when requested.
3.6 plank
tile with a ratio length divided by width superior or equal to 1,3