ISO 15003:2019 pdf download

ISO 15003:2019 pdf download.Agricultural engineering — Electrical and electronic equipment — Testing resistance to environmental conditions
1 Scope
This document provides design requirements and guidance for the manufacturers of electrical and electronic equipment for use in all kinds of mobile (including hand-held) agricultural machinery, forestry machinery, landscaping and gardening machinery [referred to hereafter as machine(s)]. The term machinery covers tractors and implements. This document gives tests for specific environmental conditions and defines severity levels for tests which relate to the environmental extremes that can be experienced in practical operation of the equipment. This document is intended to be used in determining the suitability of the equipment of these machines, for use in a specified range of environmental conditions. NOTE The severity levels given are general guidelines and not guaranteed worst-case exposure levels.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 14982, Agricultural and forestry machinery — Electromagnetic compatibility — Test methods and acceptance criteria
ISO 16750 (all parts), Road vehicles — Environmental conditions and testing for electrical and electronic equipment
IEC 60068-1:2013, Environmental testing — Part 1: General and guidance
IEC 60068-2-5:2018, Basic environmental testing procedures — Part 2: Tests — Test Sa: Simulated solar radiation at ground level
IEC 60068-2-6, Environmental testing — Part 2: Tests — Test Fc: Vibration (sinusoidal)
IEC 60068-2-11, Basic environmental testing procedures — Part 2: Tests — Test Ka: Salt mist
IEC 60068-2-13, Basic environmental testing procedures — Part 2: Tests — Test M: Low air pressure
IEC 60068-2-14, Basic environmental testing procedure — Part 2: Tests — Test N: Change of temperature
IEC 60068-2-27, Basic environmental testing procedures — Part 2: Tests — Test Ea and guidance: Shock
IEC 60068-2-30, Basic environmental testing procedures — Part 2: Tests — Test Db and guidance: Damp heat, cyclic (12 + 12-hour cycle)
IEC 60068-2-47, Environmental testing — Part 2: Tests — Mounting of specimens to vibration, impact and similar dynamic tests
IEC 60068-2-64, Environmental testing — Part 2: Test methods — Test Fh: Vibration, broad-band random (digital control) and guidance
IEC 60068-2-78, Environmental testing — Part 2-78: Tests — Test Cab: Damp heat, steady state
4.4 ISO 16750 conformance
Electrical and electronic equipment in accordance with ISO 16750 requirements that correspond to the requirements of this document conforms with this document. Annex C provides a summary of the ISO 16750 parts that contain similar test procedures as specified in this document. It provides a cross reference to assist in the determination whether an electrical and electronic equipment tested in accordance with the relevant part of ISO 16750 meets the requirements of this document or requires additional testing.