ISO 36:2020 pdf download.Rubber, vulcanized or thermoplastic — Determination of adhesion to textile fabrics
1 Scope
This document specifies a method of test for measuring the force required to separate, by stripping, two plies of fabric bonded with rubber, or a rubber layer and a fabric ply bonded together. The method is applicable when the ply surfaces are approximately plane or when they are in the form of a cylinder having an internal diameter greater than approximately 50 mm. The method is not applicable when the ply surfaces contain sharp bends, angles or other gross irregularities which cannot be excluded when cutting out test pieces. This document does not apply to coated fabrics, which are tested in accordance with ISO 2411, or textile conveyor belts, which are tested in accordance with ISO 252.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 5893:2019, Rubber and plastics test equipment — Tensile, flexural and compression types (constant rate of traverse) — Specification
ISO 6133:2015, Rubber and plastics — Analysis of multi-peak traces obtained in determinations of tear strength and adhesion strength
ISO 18899:2013, Rubber — Guide to the calibration of test equipment
ISO 23529, Rubber — General procedures for preparing and conditioning test pieces for physical test methods
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— ISO Online browsing platform: available at https:// www .iso .org/ obp
— IEC Electropedia: available at http:// www .electropedia .org/
3.1 adhesion strength
force per unit width required to cause a separation at the interface between the assembled components
Note 1 to entry: Any separation occurring at any other point, for example inside either component under test,is a failure of the component material, and does not indicate an adhesion strength. In such cases, the adhesion strength is greater than the strength of the weakest component involved.
4 Principle
The stripping force required to separate two plies of fabric bonded with rubber, or a rubber layer and a fabric ply bonded together, is measured under specified conditions using test pieces of standard dimensions in the form of a flat strip.
5 Apparatus
5.1 Test machine, power-driven and equipped with a suitable dynamometer; it shall be capable of maintaining a substantially constant rate of traverse of the moving head during the test and shall be linked to an autographic recorder or a computer with graphic capabilities for data acquisition and processing. A dynamometer without inertia (e.g. of the electronic or optical type) should preferably be used.
ISO 36:2020 pdf download
![ISO 36:2020 pdf download](https://www.onlinestandardssearch.com/wp-content/uploads/2022/10/1-2.png)